How to Install Archipel on EndeavourOS Latest

Archipel is a management tool for virtual machines, developed by Archipel Project. This tutorial will describe how to install Archipel on EndeavourOS Latest using the command line.

Step 1: Update the System

Before installing Archipel, it is best to update your system. You can do this by running the following command:

sudo pacman -Syu

Step 2: Install Required Dependencies

There are some dependencies that need to be installed before installing Archipel. Run the following command to install them:

sudo pacman -S libvirt python-libvirt rabbitmq-c

Step 3: Install Archipel

Now that the dependencies are installed, you can proceed with the installation of Archipel. Run the following command to install Archipel:

sudo pacman -S archipel

Step 4: Start Archipel Services

After installation, start the Archipel services by running the following commands:

sudo systemctl start libvirtd.service
sudo systemctl start rabbitmq.service

You can also enable the services to start automatically at boot time:

sudo systemctl enable libvirtd.service
sudo systemctl enable rabbitmq.service

Step 5: Configure Authentication

By default, Archipel does not have authentication enabled. To enable it, you can follow the instructions in the auth.conf file located in /etc/archipel. You can choose to use either a local or LDAP authentication method.

Step 6: Start Archipel Web Interface

To access the Archipel web interface, run the following command:

sudo archipel-admin

This will start Archipel and open the web interface in your default web browser.

Congratulations, you have successfully installed Archipel on EndeavourOS Latest!