Installing Pagure on EndeavourOS Latest

Pagure is a free and open-source web-based software that allows you to create and manage Git repositories, issue tracking, and pull requests. In this tutorial, we will guide you through the steps to install Pagure on EndeavourOS Latest.

Pre-requisites

Before proceeding with the installation process, make sure that you have the following requirements:

• EndeavourOS Latest installed on your system
• Root access or a user with sudo privileges
• Basic knowledge of Linux terminal commands and Git

Step 1: Install Git and Dependencies

To start with, you need to install Git and the dependencies required by Pagure. To do this, run the following command in your terminal:

sudo pacman -S git python-flask python-sqlalchemy python-flask-sqlalchemy

This command installs Git and required dependencies on your system.

Step 2: Clone the Pagure Repository

After installing Git, you need to clone the Pagure repository from GitHub. To do this, run the following command in your terminal:

git clone https://pagure.io/pagure.git

This command will download the Pagure repository on your system.

Step 3: Install Pagure

Now that you have cloned the Pagure repository, navigate to the Pagure directory and run the following command to install Pagure:

python3 setup.py install

This command will install Pagure on your system.

Step 4: Configure Pagure

Now, you need to configure Pagure by creating a configuration file. Pagure comes with a sample configuration file located in etc/pagure/pagure.cfg. To create a configuration file, you can copy the sample configuration file to a new file with the following command:

sudo cp etc/pagure/pagure.cfg.example /etc/pagure.cfg

After creating a configuration file, you need to edit it to set up the required configuration settings. You can use any text editor of your choice. For example, we are using the nano editor:

sudo nano /etc/pagure.cfg

Edit the configuration file as per your requirements and save the changes.

Step 5: Start Pagure

Finally, start the Pagure service using the following command:

sudo systemctl start pagure

You can also enable the Pagure service to automatically start at boot time using the following command:

sudo systemctl enable pagure

Conclusion

That's it! You have successfully installed and configured Pagure on your EndeavourOS Latest system. Now you can use Pagure to manage your Git repositories, issues, and pull requests. If you face any issues during the installation process, you can refer to the Pagure documentation for more information.