How to Install GNU Emacs on NetBSD

In this tutorial, we will walk through the steps to install GNU Emacs on NetBSD. The steps are as follows:

  1. Download the Emacs source files from http://www.gnu.org/software/emacs/
  2. Install the necessary dependencies.
  3. Compile and build Emacs.
  4. Install Emacs.

Step 1: Download the Emacs Source Files

Go to the Emacs download page at http://www.gnu.org/software/emacs/ and download the latest source code release. Save the file to your preferred location.

Step 2: Install the Necessary Dependencies

Before we can compile Emacs, we need to make sure all of the necessary dependencies are installed. In NetBSD, we can do this using the pkg_add command. Run the following command to install the dependencies:

sudo pkg_add gcc gmake libX11 libXaw libpng jpeg

Step 3: Compile and Build Emacs

Next, we will compile and build Emacs from source. Run the following commands to extract the source code and build Emacs:

tar zxvf emacs-*.tar.gz
cd emacs-*
./configure
make

This process may take some time, depending on your system's resources. After the build process is complete, you should see a message indicating that Emacs was successfully built.

Step 4: Install Emacs

Finally, we will install Emacs. Run the following command to install Emacs system-wide:

sudo make install

You should now have Emacs installed on your NetBSD system! To launch Emacs, simply run the emacs command in your terminal.

Congratulations! You have successfully installed GNU Emacs on NetBSD.