How to Install CasaOS on Void Linux

CasaOS is a software platform for running a home server on a Raspberry Pi, designed to be easy-to-use, powerful and self-healing. This tutorial will guide you through the process of installing CasaOS on your Void Linux distribution.

Prerequisites

Before we start, ensure you have the following requirements:

  • A Raspberry Pi board (2B/3B/3B+/4B)
  • A minimum of 16GB SD card
  • Latest version of Void Linux installed
  • Ethernet cable (for initial setup)
  • Access to the internet

Step 1: Download CasaOS

Download the latest version of CasaOS from the official website (https://www.casaos.io/). CasaOS is available in different versions for different Raspberry Pi boards. Choose the version that corresponds to your Raspberry Pi model.

Step 2: Flash the SD card

Once the CasaOS image file is downloaded, we need to write it to the SD card for installing it on the Raspberry Pi.

First, insert the SD card into your system and identify the disk device (/dev/sdX) using the following command:

lsblk

Note: Be very careful while identifying the device as selecting the wrong device may result in data loss.

Once you have identified the device, use the following command to write the image to the SD card:

sudo dd if=casaos.img of=/dev/sdX bs=4M conv=fsync

Replace /dev/sdX with the disk device identified in the previous step. This command will take some time to complete, so wait patiently.

Step 3: Boot the Raspberry Pi

Once the SD card is flashed successfully, remove it from your system and insert it into the Raspberry Pi. Connect the Ethernet cable to the board and power it up.

Step 4: Configure your network

After booting up, the Raspberry Pi will try to connect to the internet. By default, it will obtain an IP address via DHCP. If you want to configure a static IP address, follow these steps:

  • To access the configuration file for the Ethernet interface, run the following command:

    sudo nano /etc/network/interfaces.d/eth0

  • Replace the contents of this file with the following:

    allow-hotplug eth0
iface eth0 inet static
    address 192.168.1.2 # Replace with your desired IP address
    netmask 255.255.255.0
    gateway 192.168.1.1 # Replace with your gateway IP address

  • Save the file by pressing Ctrl+X, followed by Y and Enter.

  • Reboot the Raspberry Pi for the changes to take effect:

    sudo reboot

Step 5: Access CasaOS Dashboard

After the Raspberry Pi is rebooted, open your web browser and go to http://[IP_Address_of_Your_Raspberry_Pi]:8080 to access the CasaOS Dashboard.

Conclusion

That's it! You have successfully installed CasaOS on your Raspberry Pi running Void Linux. You can now configure and customize your CasaOS server according to your needs using the dashboard. Enjoy!